RDI METAL WORKS EXCALIBUR Instrucciones

Excalibur
GATE ENDS INSTRUCTIONS
Warning: Always wear safety goggles.
1.
Measure opening between posts where gate
will be located. Subtract 4" from opening.
This will be the length you will cut your rail
panel for gate (Fig 1).
Note: When marking rail, you must leave a
minimum of 1 ½" and a maximum of 2 7/8"
to the first baluster at each end (Fig 2). This
will allow sufficient railing for the gate ends
to fit to.
Measure
Mesure
1½" – 2
38,1mm – 72mm
®
2.
Confirm your marks and cut the panel to fit
using a jig saw with metal blade or a portable
band saw. All cuts must be painted prior to
final assembly.
Tip: It is recommended that you use the RDI
Cutting Jig (73018283) in conjunction with a
jig saw with metal blades or a portable band
saw for accurate and safe cutting without
scratching the finish on the rail.
Note: Rail ends may be painted with any zinc
rich primer or paint.
Fully insert the panel ends into the gate
ends (Fig. 3). Clamp or strap the assembly
together and ensure that it is square.
(Fig. 1)
(Fig. 2)
∕ "
7
8
FOR HOME, FOR LIFE
545 TILTON ROAD
EGG HARBOR CITY, NJ 08215
TEL: (877) 420-7245
FAX: (866) 277-5160
E-MAIL: [email protected]
URL: WWW.RDIRAIL.COM
3.
Pre-drill one hole on the underside of the top
and bottom rails using a 5/32" bit (Fig. 3, A).
Fasten the gate ends to the panel using the
hardware provided (#10 x ¾" Phillips Pan
Head Screws). Install gate to post using gate
hardware (sold separately).
Tip: If scratching occurs, RDI recommends
Rust-Oleum , Satin Canyon Black, Color
®
Code 249844 for Excalibur Black. For
Excalibur Bronze touch-ups, Rust-Oleum
Hammered Brown, Color Code 210880 is
recommended.
(Fig. 3)
A
®
,
®