Installing The Usb Receiver; Operation; Before Using The Product; Using The Keyboard - Medion MD 85033 Manual Del Usuario

Operation

Mouse
1. Remove the battery compartment cover
mouse 7 .
2. Insert the AA battery
polarity (+/–) is correct.
For battery replacement, remove the old battery first.
3. Close the battery compartment cover.

Installing the USB receiver

1. Remove the battery compartment cover
mouse 7 and then remove the USB receiver
compartment (see Fig. B).
2. Close the battery compartment cover.
3. Insert the USB receiver into the USB port of your computer (see Fig. C).
Operation
• The product is a plug-and-play device and requires no driver
• The maximum distance between the product and USB
• The product will automatically enter into sleep mode if it is

Before using the product

1. Make sure the batteries
7
the mouse
2. Make sure the USB receiver
computer (see chapter "Installing the USB receiver").

Using the keyboard

− The keyboard
it is successfully connected to the USB receiver
− If necessary, fl ip down the support feet
− The number lock indicator
for typing numbers.
− The caps lock indicator
− The low battery indicator
Replace the AAA battery (see chapter "Installing or replacing batteries").
10
16 into the battery compartment. Make sure the
installation and setup.
receiver is around 33 ft (10 m).
idle for about 10 minutes. Press any button to turn on the
product again.
15 /
, respectively (see chapter "Installing or replacing batteries").
17
1 is ready to use once the AAA battery
2
3 lights up when the caps lock feature is enabled.
4
13 on the underside of the
13 on the underside of the
16
are installed in the keyboard
is inserted into the USB port of your
5 to tilt up the keyboard.
lights up when the number pad is enabled
lights up when the battery power level is low.
17 from the battery
15 is installed and
17
.
1
and in