Switching On The Instrument - R&S ZVA-Z75 Manual De Instrucciones

® R&S ZVA-Z75, -Z90, -Z110, -Z140, -Z170, -Z220, -Z325, -Z500
cables. Rohde & Schwarz offers three different adaption kits R&S ZCAK to meet the
requirements of different NWAs:
●
For the R&S ZVA24 var. 28 and the R&S ZVA40 var. 48 (NWAs with four sources),
Rohde & Schwarz offers the adaption kit R&S ZCAK var. 24 (order number
1323.7746.24).
It includes a power splitter and two right angled SMA (m-m) adapters.
●
For the R&S ZVA50, Rohde & Schwarz offers the adaption kit R&S ZCAK var. 50
(order number 1323.7746.50).
It includes four 1.85 mm (f) to 2.92 mm (m) adapters and four 1.85 mm (m) to
2.92 mm (f) adapters.
●
For the R&S ZVA67, Rohde & Schwarz offers the adaption kit R&S ZCAK var. 67
(order number 1323.7746.67).
It includes a power splitter, two right angled SMA (m-m) adapters, three
1.85 mm (f) to 2.92 mm (m) adapters and four 1.85 mm (m) to 2.92 mm (f) adapt-
ers.
2.4.6 Connecting the Converter to the DC Supply
An external DC power supply and several plug adapters are provided with the instru-
ment. Select the appropriate adapter and attach it to the power supply. To remove a
mounted adapter, press the small button next to the adapter and push the adapter
away from the button.
Connect the power supply to the "9 V / MAX. 1.1 A DC" input on the rear panel (see
Chapter 2.3.2, "Power Supply
power supply supports input AC voltages between 100 V and 240 V and frequencies
between 47 Hz and 63 Hz.
A lit LED next to the standby switch indicates that the power supply operates appropri-
ately. If neither of the two LEDs is lit, check the fuse of the instrument (see
ter 2.4.9, "Replacing
R&S ZVA-Z500 converters
The external DC power supply units of R&S ZVA-Z500 converters support higher out-
put powers; the DC input connector at the rear panel is labeled "9 V / MAX 1.6 A".
Always use the DC power supply delivered with your frequency converter.

2.4.7 Switching On the Instrument

The standby toggle switch is at the rear panel (see
on page 8). To switch the instrument to ready state, press the key. The green LED next
to the switch must be lit now.
Getting Started 1307.7039.62 ─ 11
Connector", on page 9) and to a power outlet. The
Fuses", on page 16).
Preparing for Use
Putting the Converter into Operation
Chapter 2.3.1, "Standby
Chap-
Switch",
15