AKO Electronica 5238 Instrucciones De Montaje página 2

Kit de terminación
5238H001
HOJA TÉCNICA
INSTRUCCIONES DE MONTAJE PARA CABLES:
ASSEMBLY INSTRUCTIONS FOR CABLES:
Extremo frío de conexión / Connection cold lead
1
3
Extremo final / End seal
6
8
0
1
2
3
Edición 05
Cortar el cable como mínimo a 500 mm del
primer contacto (hendidura).
Cut the heater at minimum 500 mm from
the first contact (depression).
Colocar un tubo termorretráctil Nº 1 según
se muestra y retractilar.
Position one heat-shrink sleeve No.1
as show, and shrink.
Cortar 16 mm de aislamiento.
Para extraer el aislamiento hay que
cortarlo parcialmente en todo su
contorno, y doblarlo hacia ambos lados
hasta separarlo.
Cortar el conductor de calentamiento de
forma que su extremo quede debajo del
aislamiento.
Cut 16 mm of insulation.
To remove the insulation it must be cut
partially all the way around, and folded
towards both sides until it separates.
Cut the heating element so that it end is
covered by insulation.
Colocar el tubo Nº 2 según se indica y
retractilar.
Pasar inmediatamente al punto 9.
Position the heat-shrink sleeve No. 2 as
shown, and shrink.
Move immediately on the Step 9.
4
5
6
7
( 02 de 04 )
AKO-1212, AKO-5231
AKO-5232, AKO-5235, AKO-7125XX
2
4
5
7
9
10
11
8
9
www.ako.com
Cortar 120 mm de aislamiento.
Para extraer el aislamiento hay que
cortarlo parcialmente en todo su
contorno, y doblarlo hacia ambos lados
hasta separarlo.
Cortar el conductor de calentamiento de
forma que su extremo quede debajo del
aislamiento.
Cut 120 mm of insulation.
To remove the insulation it must be cut
partially all the way around, and folded
towards both sides until it separates.
Cut the heating element so that it end is
covered by insulation.
Dejar 6 mm sin aislamiento en conduc-
tores.
Leave 6 mm without from insulation on
conductors.
Cortar el cable a 100 mm del primer
contacto (hendidura).
Cut the heater at 100 mm from the first
contact (depression).
Cortar 8 mm uno de los conductores.
Cut 8 mm one of the conductors.
Presionar el extremo del tubo Nº 2 hasta
que quede pegado y sellado.
Squeeze the No. 2 sleeve end to stick and
seal.
12
13
14
15
16
17
loading