Contents Of Package; Tools Needed - PITT Front Side Instrucciones De Instalación

Instructions for installation of support set

Contents of package:

2x support beams
4x inserts
16x cross-point screws 4,2x16 mm
1. Determine the dimensions of the cabinet and cut the support
beams with the saw. ATTENTION! Correct length of the beam =
the dimension of cabinet on the inside - 4 mm.
3. Place the beams between the cabinet and position it against
the under side of the PITT
POSITIONING, SEE STEP 4.
EN
5. Push the beams firmly against the underside of the PITT
cooking unit and tighten the lower two screws by hand. Repeat
this step for the other side of the cabinet.
Installation FS 2019 NL-EN-FR-DE-ES-IT EU PC 2 combi.indd 8
® cooking unit. ATTENTION: FOR THE
2. Place the inserts into the ends of the beams that have been
cut to size.
* Minimum distance of 80 mm
4. Position the beams in such a way that the screws, gas
connection and the electricity block are freely accessible.
6. Push the beams firmly against the underside of the PITT
®
cooking unit and tighten the upper two screws completely.
Then, tighten the lower screws completely.

Tools needed:

• Measuring tape
• Cross-point screwdriver
• Metallic saw
*
*
®
4-4-2019 17:59:59