Toparc 058866 Manual De Instrucciones página 8

INSPECTION OF PACKAGE CONTENTS
The package contains: - n ° 1 aspirateur pneumatique
- n ° 1 sac de collecte de poussière en matière polyester
For packaging waste disposal attain to local regulations in force, including recycling disposal if requested.
WARNINGS
Safety and accident prevention instructions
- This machine can only be operated by trained people in charge; machine no intended to be operated by kids or men-
tal-sensorial defective people;
- before use, users should be provided with information, instruction and training for the use of the appliance and the
pollutant it is used for, including the right method for the safe removal and disposal of the substances collected;
- it is necessary to provide an adequate air change rate in the room if the exhaust air is returned in the room. Reference
to National Regulations is necessary;
- the temperature of the work area must be between 10°C and 35°C with humidity between 50% and 90%;
- the surface on which the machine rests must not exceed a maximum 10 degree gradient;
do not expose the machine to rain and low temperatures;
do not lift and transport the machine by the handle with a lifting device.
Explosion or fire hazard
- Do not vacuum flammable or explosive dust;
- do not vacuum sanding dust from surfaces treated with paints that have not completed the catalyst cycle;
- do not vacuum sparks or white hot shavings;
- immediately disconnect the vacuum from the electrical mains if dust is ejected from air outlet;
- do not vacuum flammable or explosive liquids (i.e. petrol, thinners, etc.);
- do not vacuum aggressive liquids or substances(i.e. acids , bases, solvents, etc.).
ATEX Version
The machine complies with the ATEX 2014/34/EU Directive and the harmonized standards contained in the Declaration
of Conformity as a Category 3D device.
Appropriate indications of possible explosive atmospheres (as specified by the ATEX 2014/34/EU Directive) must be
applied near the area of use of the device.
The device contains dust deposits and potentially explosive atmospheres. In particular, the operator must avoid introdu-
cing sources of ignition in the vicinity or inside the unit or in the bucket such as: flames, gases or hot surfaces, electrical
parts, electrostatic charges, mechanical sparks.
The label, technical data, and ATEX marking are located on the rear panel.
Warning! Read all safety notes and directions. JBDC Spa assumes no responsibility for direct or indirect
damages resulting from non-compliance with this manual.
Use according to purposes
This machine complies with the EN60335-2-69 reference standards for industrial applications. Machine suitable for dust
with a maximum workplace concentration ≥ 0.1 [mg/m³] and wood dusts (Class M - Medium HAZARD).
"M" Version
Extracting dust with a Kst value > 200 (bar*m/s) and/or an ignition energy < 10 mJ is not permitted. Please observe
local regulations.
Refer to any safety regulations applicable to the treated materials
8
Professional pneumatic vacuum cleaner
EN