Adjusting The Alarm Time; Additional Functions; Reset Hole; Backlight Intensity Level - Oregon Scientific RM928N Manual De Instrucciones

#1
#2

ADJUSTING THE ALARM TIME

To adjust the Alarm Time, make sure that
first.
Diagram Instructions
1. Press and hold ALARM button.
2. Adjust the minute. Press ALARM
2. indicates that the 1st
alarm display is now shown.
Press + or – on the Mode
Switch to toggle the 1st
alarm on (Figure #1) or off
(Figure #2).
3. Press ALARM to display
nd
the 2 alarm
the alarm on or off using +
or – on the Mode Switch.
4. Press the Mode Switch
anytime to exit alarm
mode.
or alarm displays
Adjust the hour. Press ALARM
again when done.
when done.

ADDITIONAL FUNCTIONS

RESET HOLE

If the clock behaves strangely or stops responding, insert and
press a blunt stylus into the clock's Reset Hole. The clock will
then be reset to its original factory setting.
. Toggle

BACKLIGHT INTENSITY LEVEL

Press and hold Snooze/Light to select the Backlight Intensity
level (Lo or Hi). Then, press + or – on the Mode Switch to toggle
between the two settings.
NOTE Choose "Lo" to conserve batteries during the daylight,
while "Hi" is best during nighttime when additional backlight
intensity is needed.
9