LED FLAT PANELS
Models: 65/347, 65/348, 65/351,
65/352, 65/355, 65/356
INSTALLATION AND SAFETY INSTRUCTIONS
SAFETY:
•
electric shock, falling parts, cuts/abrasions, and other hazards read
• Before installing, servicing, or performing routine maintenance upon
this equipment, follow these general precautions.
• Commercial installation, service and maintenance of luminaries should
If you are unsure about the installation or maintenance of the
local electrical code.
• To prevent wiring damage or abrasion, do not expose wiring to edges
of sheet metal or other sharp objects.
• Do not make or alter any open holes in an enclosure of wiring or
electrical components during kit installation.
WARNING:
•
to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the
luminaire label information.
• All connections should be capped with UL approved wire connectors.
DROP CEILING INSTALLATION STEPS:
NOTE:
1.
2.
3. Remove ceiling
4.
panel down.
angle up into ceiling
and lower into place.
WIRING INSTRUCTIONS:
© Copyright 2018 Satco Products, Inc. 09/18
Suitable for suspension or recessed installation.
(Suspension installation kit available separately)
Installation Selections Chart
CAUTION:
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these
may be hazardous to children.
•
before handling.
WARNING:
• Total number of panels allowed on a single circuit using
branch circuit wiring is 18.
• Over 90 minutes emergency working time
5.
ceiling channels.
"
Size
L x W x H (mm)
2 x 2
602 x 602 x 10
2 x 4
602 x 1209 x 10
L x W x H (inch)
23.7 x 23.7 x 0.4
23.7 x 47.6 x 0.4
Satco Products, Inc.
Brentwood, NY 11717