Uline H-9045 Guia De Inicio Rapido

H-9045, H-9275
HARD-WIRED EXIT SIGN
TOOLS NEEDED
Flathead Screwdriver
CAUTION! When using electrical equipment,
always follow basic safety precautions, including:
• Do not use outdoors.
• Do not mount near gas or electric heaters.
• Do not let power cords touch hot surfaces.
• Use caution when servicing batteries to avoid
possible shorting.
• Mount in locations and at heights where it
will not readily be subjected to tampering by
unauthorized personnel.
• Use of accessories not recommended by the
manufacturer may cause an unsafe condition.
BACK MOUNTING
1. Unit comes with EXIT panels on front and back.
Remove back EXIT panel and replace with back
plate. Drill 1/4" holes into oblong knock outs on back
plate that correspond to junction box holes to be
used. (See Figure 1)
Figure 1
Oblong Knock Outs
EXIT Panel
PAGE 1 OF 9
1-800-295-5510
uline.com
Phillips Screwdriver
INSTALLATION
Junction
Wire Nuts
Box
Back Plate
Plastic
Housing
Diffuser
Snap-in
Directional Arrow
SAFETY
• Do not use this equipment for anything other
than intended use.
• Before wiring to AC service, turn off AC power
at fuse or circuit breaker.
• Disconnect AC power and unplug battery
before servicing.
• Only use specified lamps in the fixture.
NOTE: Battery in unit may not be fully charged.
After AC service is supplied to unit, let battery
charge for at least 24 hours before performing
any tests.
2. Feed transformer input leads through center hole of
back plate and make the proper connections.
(See Figures 2-3)
NOTE: If using 120VAC, connect black and white
leads to building utility.
NOTE: If using 277VAC, connect orange and
white leads to building utility.
NOTE: In some cases, not all leads will be used.
Cap off unused wire.
120VAC
Connect black and white
leads to building utility.
Cap Unused
Orange Wire
Figure 2
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
277VAC
Connect orange and white
leads to building utility.
Cap Unused
Black Wire
Figure 3
0221 IH-9045