Media Id; Receive Tray - Codonics Horizon GS Manual Del Usuario

WARNING: Do not attempt to manually defeat the top cover closed sensor that is on the right
inside wall of the imager, shown in the following figure. Doing so could result in personal injury.

Media ID

•
The latest versions of the imager support only the Media ID media authentication system. They
do not support reading IDs from barcode labels on the media cassette to authenticate media.
•
Unlike with previous imagers that required an external device to be attached to the imager, the
Media ID reader is internal to the imager. The Media ID is detected when you insert a media
cassette. If the media cassette is successfully authenticated, a confirmation message displays on
the front panel.
•
Once the Media ID is read, the media cassette can only be used with that imager. You cannot
use the cassette with another imager.
NOTE: If the imager does not recognize the Media ID on a cassette, contact Codonics Technical
Support. In the latest versions of the imager, media cassette barcodes cannot be entered manually at the
front panel.

Receive Tray

The latest versions of the imager include only one receive tray. Media pulled from any of the supply
slots will be placed in this receive tray.
To remove the receive tray:
1. Open the top cover. Refer to "Opening the Top Cover."
2. Lift the front of the receive tray up.
3. Pull the receive tray out away from the imager.