Troubleshooting - Temper Koban KDP5 Manual Del Usuario

Button
Adjustment on sensitivity of detector
By pressing
Each time the user presses the button, the sensitivity of sensor
would increase or decrease 10% with indication of red LED
flashing.
By pressing
By pressing
When the sensitivity of sensor is at its highest or lowest level
which is confirmed by red LED keeping on for approx. 2sec.

Troubleshooting

Problem Possible cause
Detector fails 1. Exceed the
to receive transmission range.
signal 2. Low battery power.
3. Detector works
abnormally.
No signal 1. Low battery power.
2. Press two or more
buttons once.
Fail to transmit In locked mode.
signal
www.grupotemper.com
KDP5 remote control
Function
buttons to set the sensitivity of sensor.
button to increase the sensitivity of sensor.
button to decrease the sensitivity of sensor.
Suggested solution
1. Operate within transmission range,
and ensure KDP5 RC aims directly to
the detector.
2. Replace a new battery.
3. Check the trouble of detector, then
refer the TROUBLE SHOOTING of
detector manual for reparing.
1. Replace battery.
2. Press one button once.
Unlock the controller.
Remote control
Instructions manual | 17