ASROCK K7Upgrade-600 Manual Del Usuario página 11

2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PWR1
(see p.2, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
JR1 / JL1
(see p.2, No. 27)
Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear
panel audio connectors can work.
Clear CMOS
(CLRCMOS2)
(see p.2, No. 18)
Note: CLRCMOS2 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short the Clear
CMOS jumper for 5 seconds. After shorting the Clear CMOS jumper, please
remove the jumper cap. However, please do not clear the CMOS right after you
update the BIOS. If you need to clear the CMOS when you just finish updating
the BIOS, you must boot up the system first, and then shut it down before you
do the clear-CMOS action.
ASRock K7Upgrade-600 Motherboard
Short
Setting
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.
2-pin jumper
Open
1 1 1 1 1 1 1 1 1 1