Tabla de contenido
Idiomas disponibles
Idiomas disponibles
installation
instructions
/
2. Preparation
to Remove
the
Air Conditioner
Slide-Out
Chassis
A. Remove total of (4) Philips screws securing
the chassis to the cabinet. There are (2) screws
on each side. The set of screws closest to the
front of the unit secure the front panel to the
cabinet. The set of screw closest to the rear of
the unit secure the cabinet to the chassis.
See (Fig. 1).
B. Remove the front panel assembly from the
cabinet by gently pulling it.
C. Grasp the pull handle at the front of the
slide-out chassis and carefully slide the
air conditioner out of the cabinet. See (Fig. 2).
Please seek assistance
for this procedure.
NOTE: Screws must be reinstalled
upon
completion
of the window
installation to
secure slide-out
chassis.
3. Assembly
of the upper & lower channels to
the cabinet
A. " L" Shaped Top Channel: Stick the double
adhering seal to the " L" shaped top channel, and
then Install the "L" shaped top channel to the
cabinet as shown in (Fig. 3) using (5) 1/4" screws.
B. "n" Shaped Bottom Channel installed as
shown in (Fig. 3)using (4) 1/4" screws.
NOTE: For 18K to 24K models,
the bottom
channel
has been factory-installed,
and their shapes may
differ from the others, but their functions
are similar.
4. Assembly
of the side shutters
(curtains)
to the cabinet.
Slide the shutters into the top and bottom
channels as shown in (Fig. 4). The shutters are
identified (on each frame) as "left" & "right". Attach
the shutters to the cabinet using (4) 1/4" screws
on each side.
Right side
Philips screws
Fig. 1
Colt
\\,
Chassis y
Pull Handle
Fig. 2
Ooubie
_-
1/4" Screw
_j
..........
_ :_',Ch ....
1
For 10K to 12K models
For 18K to 24K models,
(Factory-Installed)
Fig. 3
Shutter Frame
1/4" screw
/
Rrght Shutter
Fig. 4
m7m
Tabla de contenido
