Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Step2
6.
Connect top short beam (F), long support beam (J), top long beam (E) and short support beam (K) using
bolt (AA), flat washer (DD), and assemble all corners before tightening. (Fig.6) Repeat on all sides.
7.
Connect top short be am (F), top lo ng beam (E) and long support beam (J), using bolt (AA) and flat
washer (DD), assemble all corners before tightening. (Fig.7) Repeat on all sides.
8.
Connect one side of the top long bea m (E) to one si de of the top sho rt bea m (F), using bolt (II), fla t
washer (DD) and nut (EE), assemble all corners before tightening. (Fig.8)
9.
Connect the other side of the top long beam (E) to the other side of the top short beam (F), using bolt (II),
flat washer (DD) and nut (EE), assemble all corners before tightening.(Fig.9)
10.
Connect oblique be am co nnector (G) and top short beam (F ), using b olt (AA) and flat wa sher (DD),
assemble all corners before tightening. (Fig.10) Repeat for each beam.
11.
Connect short oblique beam (C) to beam connector (G), using bolt (CC), flat washer (DD) and nut (EE),
assemble all corners before tightening. (Fig.11) Repeat for each beam.
12.
Insert long oblique beam with small roof bar (B) into long pole of top connector (A) and one side of long
oblique beam (D) into short pole of top connector (A). (Fig.12)
13.
Insert one side of long beam with small roof Bar (B) into short oblique beam (C). Then connect using bolt
(AA) and flat washer (DD) and lock tight. (Fig.13)
14.
Connect long oblique b eam (D) to top long be am (E) using bolt (CC), flat wa sher (DD) an d nut (EE),
assemble all corners before tightening. (Fig.14)
Step3
Fig. 18
S
H(I)
(HH)
R
Fig.17
R
Fig.17
Fig.16
P
Q
Fig.15
Fig.18
E(F)
(HH)
S
Fig.19
Fig 19
O
GG
N
Tabla de contenido
