Mount To 4 In. Housing - ETI 53182201 Manual De Uso Y Cuidado

Mount to 5 in./6 in. Housing without C-Clamps (continued)
5
Inserting the friction clips into the
recessed can
□ Insert one side of the downlight into the recessed
can and fi rmly push against the friction clip (C),
while inserting the other side into the can housing .
A

Mount to 4 in. Housing

Part # DL-4-10-827-SV-D / Model # 53182201, Part # DL-4-10-830-SV-D / Model # 53182211 should be installed in 4 in . housings only .
1
Turning off the power
□ Make sure the power is turned off at the source to
the recessed can housing where the fi xture will be
installed .
□ Remove the existing bulb and trim, revealing the
socket .
NOTICE: Stick the replacement label
on the inner wall of the recessed housing
before installation .
6
Pushing the LED light module in to
t he recessed can
□ Once both clips are inside, carefully push the LED light
module (A) up into the recessed can housing until the
trim is fl ush with the ceiling surface .
C
2
Connecting the socket adapter
□ Screw the medium base (E26) socket adapter (E) into
the socket in the recessed housing .
6
E
Please contact 1-855-384-7754 for further assistance .
WWW .ETISSL .COM