Pipettor Holder And Carousel; Installing The Pipettor Holder; Carousel Stand; Calibration Tool (Also Tube And Id Window Opener) - Biohit mLINE Manual Usuario

5. Pipettor holder and carousel stand
For convenience and safety always keep the pipettor vertically on its
own holder or carousel stand when not in use.
Cat.No. Product
725600 Biohit
725610 Biohit

5.1. Installing the pipettor holder

1. Clean the shelf surface with ethanol.
2. Remove the protective paper from
the adhesive tape.
3. Install the holder by pressing it
against the edge of the shelf (Fig. 2).
4. Place the pipettor onto the holder.

5.2. Carousel stand

A convenient and ergonomical
Carousel Stand (Fig. 3) for six
m
Biohit LINE pipettors is also available.
6.

Calibration tool (also tube and ID window opener)

The calibration tool is designed for the following purposes (Fig. 4):
1. Tool for recalibration (A).
2. Opening tool for the ID window and lid of the calibration nut (B).
3. Opening tool for the tubes (C).
m
LINE Carousel Stand
m
LINE Pipettor Holder
Fig. 4.
Fig. 2.
Fig. 3.
B
C
5
A