Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ANOMALIES, CAUSES, REMEDIES
Error message
The motion detector switches with
delay
Maximum range not reached
Motion detector switches permanently
or switches for no reason.
No reaction to passing vehicle.
Causes
Detection area not supported
Front travel
Detector is mounted too low.
The difference between the
ambient temperature and the
heat source is too small.
Thermal
instability
detection zone caused by:
- trees, reflections on water
etc...
- wind, rain or fans.
- direct or indirect sunshine.
The vehicle's engine is not yet
warm enough.
Well insulated motor.
www.uniteck.fr
Solution
Adjust the detection area
Set your detector higher.
in
the
Reorient the motion detector,
if possible avoid these
interference zones.
No remedy
EN
13/24
Tabla de contenido
