Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation Instructions
LOCATION
1. Select a place with a strong, level fl oor.
2. Allow 5 inches (12.7 cm) of space between the back of the refrigerator and any adjacent wall.
3. Avoid direct sunlight and heat. Direct sunlight could damage the unit. Heat sources nearby will cause higher electricity
consumption.
4. Avoid moist places. Too much moisture in the air will cause frost to form very quickly on the evaporator, and your
refrigerator will have to be defrosted more frequently.
This unit is 29.94 inches / 76.05 cm wide by 67.26 inches / 170.85 cm high by 28.48 inches / 72.35 cm deep, please make
sure that you leave the minimum amount of space between the unit and all surrounding walls and vents (see location sec-
tion). Do not cover any of the ventilation openings with any material as the unit needs adequate space to breathe.
Place the appliance fi rmly on a solid base. Some appliances have adjustable feet on the front side; use them to level the
appliance (some models only).
NOTE: This appliance is intended for FREE-STANDING INSTALLATION ONLY, and is NOT intended to be built-in.
This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor operation.
Note: Do not operate this unit where the ambient room temperature is below 5°C (41°F)
FEATURES
1. Light Switch
2. Control Panel
3. LED Light
4. Airfl ow Outlet
5. Temperature Sensor
6. Refrigerator Shelf
7. Airfl ow Inlet
8. Vegetable Crisper
9. Butter Keeper
10. Adjustable Door Bin
11. Large Capacity Door Bin
12. Adjustable Feet: Please adjust to level your unit.
HANDLE INSTALLATION
The unit must be unplugged before installing the handle
1. The refrigerator ships with the handle inside
2. To install the handle, remove packaging and position the handle over the
door handle posts
3. Once the handle is in position on the posts insert the small hex screws into
the handle bracket and tighten them with the allen key provided. Turn until
snug but do not over tighten
3
Tabla de contenido
