DeWalt D259803ñ Guia De Inicio Rapido

HAMMER TRUCK
D259803
FOR USE WITH D25980
WARNING: Improper operation or maintenance of this product could
result in serious injury and property damage. Read and understand
all warnings and operating instructions in the pavement breaker's
instruction manual before operating or performing maintenance on this
equipment.
WARNING: Turn off the pavement breaker and unplug from
the power source before making any adjustments or removing or
installing attachments or accessories.
Contents (Fig. 1, 2)
A. Handle
B. Strap
C. 1" (25.4 mm) chisel bit (1)
D. 3" (76.2 mm) chisel bit (1)
E. 1" (25.4 mm) bull point
chisel bits (2)
F. Foot plate, grooved
Assembly (Fig. 3)
NOTE: Assemble pegged foot plate (not shown) if transporting
pavement breaker without bit installed. Place the pavement breaker
on peg for stability when transporting.
FOOT PLATE
1. Slide bottom end of handle (A) onto foot plate (F or G).
2. Insert screws (I) in holes as shown.
3. Place washers (J) and nuts (K) onto the screws as shown.
4. Tighten to secure footplate.
WHEELS
1. Place the wheel (L) onto the axle.
2. Place the washer (M) onto axle against the wheel hub.
3. Insert the split pin (N) through hole in axle.
4. Bend the split pin legs to secure wheel into place.
5. Repeat for the second wheel.
IMPORTANT! Maximum tire pressure: 30 psi (2 bar)
Usage (Fig. 1, 4)
1. Place pavement breaker (O) onto hammer truck.
NOTE: If a bit is inserted, make sure grooved foot plate (F) is
assembled and bit is resting in groove (P).
2. Secure pavement breaker to hammer truck with strap (B) as
shown.
3. Wrap power cord (Q) around cord wrap (R).
Transporting
WARNING: Risk of unsafe operation. Ensure proper footing and
use caution when rolling hammer truck so it does not tip or cause loss
of balance.
WARNING: Risk of unsafe operation. Do not exceed load limit
of 165 lbs. (75 kg). Personal injury may result. Refer to the warning
label (Fig. 1, H).
CAUTION: Risk of unsafe operation. Do not transport unsecured tool.
Personal injury may result.
1. With pavement breaker (O) secured, grasp handle (A) and slowly
tilt hammer truck back so it can be rolled on the tires.
2. When location is reached, slowly lower hammer truck to rest on
foot plate.
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286
E
The following are trademarks for one or more D
the handgrip; the kit box configuration; and the array of lozenge-shaped humps on the surface of the tool.
G. Foot plate, pegged
(not shown)
H. Max load 165 lbs. (75 kg.)
warning label
WALT power tools: the yellow and black color scheme; the "D" shaped air intake grill; the array of pyramids on
E
FIG. 1
A
H
J
F
P
FIG. 3
L
N
M
I
J
F
FIG. 4
(SEP06) Form No. 495558-00
FIG. 2
B
Q
C
L
K
J
I
O
A
B
Copyright © 2006 D WALT
E
O
R
D
E
M
N