Using The Radio; Connecting Two Speakers - ION POWER GLOW 200 Guia De Incio Rapida

Using the Radio

Selecting a Radio Station:
1. Press the Mode button on the unit or remote control until the FM Radio is selected as the audio
source.
2. Adjust the radio frequency by pressing the
remote control. To "seek" (skip to a radio frequency with a clear signal), press and hold the
(Previous) or
Saving a preset:
1. Select the radio station that you want to save as a preset.
2. Press and hold the
one of the 30 available preset numbers (P01–P30).
3. Use the (Previous) or
preset numbers and find the one that you would like to save the station to. The preset numbers will
update on the Display as you scroll through them.
4. Once you've found the preset number that you would like to save the station to, press the
(Play/Pause) button. The preset will then be saved.
Selecting a preset station:
1. While the radio is on, press and hold the Mode button on the unit or the remote control.
2. Use the (Previous) or
saved presets. The Display will show the preset numbers as you cycle through them (P01–P30).
3. Once you find the preset number for the station you want to hear, press the
on the unit or the remote control to play the preset station.

Connecting Two Speakers

To link two Power Glow 200 speakers:
1. With the Power Switch on each speaker turned to the off position, connect each speaker to a
power outlet.
2. Plug a 1/4" cable into the Mix Out located on the rear panel of one Power Glow 200 speaker. This
speaker (the master) is the one to which you will connect audio sources such as a Bluetooth device,
microphone, or USB flash drive.
3. Plug the other end of the 1/4" cable into the 1/4" Aux Input on the rear panel of your second Power
Glow 200 speaker. This second speaker will receive the audio from any devices connected to the
first speaker (the master).
4. Power on both speakers using their Power Switches.
5. Connect your audio sources to the first speaker (the master).
6. Make sure that each speaker's Master Volume control is set to the same position.
7. With one of your audio sources playing, gradually turn up the Aux Input Volume on the second
Power Glow 200 speaker until the volume of this speaker matches the volume of the first speaker
(the master).
10
(Next) button on the unit or the remote control.
(Play/Pause) button on the unit or the remote control. The Display will show
(Next) buttons on the unit or remote control to scroll through the
(Next) button on the unit or the remote control to cycle through the
(Previous) or (Next) button on the unit or the
(Play/Pause) button