Taurus Alpatec RCMB27 Manual Del Usuario página 10

English
WALL HEATER
RCMB 27
DESCRIPTION
A Air outlet
B Control panel
C Remote control
D Screws
E Wall Plugs
I ON/OFF
II Mode selctor
III Swing
IV Auto/Window open function
V Week timer
VI Decrease
VII Timer
VIII Child lock
IX Delay-on/off time
X Room temperatura display
XI Increase
XII Set hours/minutes/day
1 Fan function
2 Heat intensity I (1000W)
3 Day
4 Heat Intensity II (2000W)
5 ON button / MODE button / SWING button
6 OFF button
7 Open window
8 Thermostat
9 Timer
10 Week program
11 Delay
12 Swing
13 LED Display
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Fully extend the appliance's power cable befo-
re each use.
- Do not use the appliance if the on/off switch
does not work.
- If you use the appliance in a bathroom or simi-
lar place, unplug the appliance from the mains
when it is not in use, even if it is only for a short
while, as proximity to water involves a risk,
even if the appliance is disconnected.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Make sure that dust, dirt or other foreign ob-
jects do not block the fan grill on the appliance.
- Never leave the appliance unattended while in
use.
- Never leave the appliance connected and un-
attended if is not in use. This saves energy and
prolongs the life of the appliance.
- Do not use the appliance to dry textiles of any
kind.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
- Install the appliance away from flammable ma-
terial such as textiles, cardboard or paper, etc.
- Install the appliance a minimum distance of
50cm away from combustible materials, such
as curtains, furniture ...
- Ensure that neither the air access nor exit
become either totally or partially covered by
drapery, clothing, etc., as this increases the
risk of fire.
- Appliance must be installed at least 2 m above
the floor.
- In the event that the appliance is mounted on a
bathroom wall, position it in such a way that the
socket, power supply cable, switches or other
controls are not within the reach a person in
the bath, shower or at the wash-hand basin.
- This appliance must be fixed into a wall. The
minimum distance between the floor and the
lower part of the appliance is 2m
- The appliance requires suitable ventilation in
order to work properly. Leave a space of 20 cm
above the appliance and 25 cm on each side.
(Fig.1)
- Do not cover or obstruct any of the openings of
the appliance.
- The plug must be easily accessible so it can be
disconnected in an emergency.