Cleaning And Maintenance - Sonia Maia High H2301 Manual De Instrucciones

- On the
will light up.
● Set the timer using the
choose the operating time of the machine, in a
range of between 1 and 30 minutes.
● Set the power using the
choose the power of the machine, in a range of
between 1 and 9.
● Use the
- When running, the
- When paused or on standby, the
light up.
OPERATION
● Direct electrotherapy:
- Select the appropriate electrode for the
treatment, set the timer and decrease power to
the minimum.
- Hold the high frequency handpiece and press
until the run indicator
- Then bring the electrode closer to the area of
the skin to be treated until it meets the skin and
set the power
- At the end of the treatment, reduce the power
and press the
pause indicator
enters pause mode.
- Then you can remove the electrode from the
patient's face.
● Indirect electrotherapy:
- The procedure is the same as above, except that
the patient should hold the straight electrode in
their hand from the beginning of the treatment.
- The operator's electrode should not come into
contact with the patient's electrode.
- During the treatment, the operator should keep
one hand on the patient's face.
Bear in mind:
● Humming sounds indicate that the high frequency
electrode is working normally.
● If using direct electrotherapy, when the electrode
is less than 2.5 cm away from the skin, a spark will
occur. This is why you should set the power to the
minimum and increase gradually. If the spark still
occurs, you can use a dry cotton cloth to cover the
face.
●
should be off when placing and removing
the high frequency electrode.

CLEANING AND MAINTENANCE

4
button, the pause indicator
or buttons to
or buttons to
button to start or stop the device.
indicator will light up.
indicator will
lights up.
gradually.
button until the
lights up and the machine
● Before cleaning the device, unplug it from the
mains.
● Clean the device with a soft, dry cloth. Do not use
liquids to clean it.
● After each use, the various components and
accessories must be sterilised and left to dry.
● For maintenance or repairs of any part of the
product, please contact your distributor or
specialised technician.
RECYCLING
If you need to dispose of the product or any of its
parts or accessories, please check and respect the
laws and regulations applicable to waste management
and environmental protection.