Remote Control - Faber hoods Skypad 2.0 Manual Del Usuario

Controls
L T1 T2 T3
Button Function
L
Turns the lights ON/OFF at
maximum intensity.
Press and hold the button
for approximately 4 seconds,
with all the loads turned off
(Motor and Lights), to turn
the Activated Charcoal Filter
alarm on/off.
T1
Turns the motor on/off at
speed one.
Press and hold the button
for approximately 2 seconds,
with all the loads turned off
(Motor and Lights), to reset
the Activated Charcoal Filter
alarm.
S1
Signals the Metal Grease
Filter saturation alarm, indi-
cating that it is necessary to
wash the filters. The alarm
is triggered after the Hood
has been in operation for
100 working hours.
When this is activated, it sig-
nals the Activated Charcoal Fil-
ter saturation alarm, indicating
that the filter must be changed;
the Metal Grease Filters must
also be washed. The Activated
Charcoal Filter saturation alarm
comes into operation after the
Hood has been working for 200
hours.

Remote control

The appliance can be controlled
using a remote control powered
by a 1.5 V carbon-zinc alkaline
batteries of the standard LR03-AAA
type (not included).
• Do not place the remote control
near to heat sources.
• Used batteries must be disposed
of in the proper manner.
S1
S1
L T1 T2 T3 T4
T4
Led
-
LED S1
flashes twice
= alarm ON.
-
LED S1 turns
OFF (Fixed or
Flashing).
Fixed
Flashing
Button Function
Turns the Motor On/Off.
Decreases the speed of the Motor. -
Increases the speed of the Motor.
INTENSIVE
- Activates Intensive speed from any
other speed.
To disable it, simply press the
same button again or turn the
motor off.
- Intensive speed is timed to run
for 6 minutes. At the end of the
6 minutes the system
automatically returns to the speed
set previously.
Press briefly for the Delay Function:
Can only be activated if the Inten-
sive or 24h function is not active.
Activates and deactivates total
shutdown of the hood (motor+lights)
after 30 minutes:
To disable the Delay, simply press
the button again or turn the motor
off.
Press and hold for 2sec for the
24H Function:
Can only be activated if the Inten-
sive or Delay function is not active.
Activates and deactivates the 24H
function for 10 minutes every hour,
for 24 hours. After this time it is
deactivated.
Turns the Hood lights On/Off at
maximum intensity.
Press and hold for 2sec to turn
the Hood lights On/Off at reduced
intensity.
Lighting
• For replacement contact technical
support ("To purchase contact
technical support").
Display
-
-
-
The led on
the motor
button (on
the hood
controls) will
flash once
every 0.5
seconds.
The led on
the motor
button (on
the hood
controls) will
flash once
every 2
seconds.
-
-
5