Building-In - Gorenje Tiki OGB 30 SEDD/UNI Instrucciones

Dear buyer, we thank you for purchase of our product.
Prior to installation and first use of the electric water heater, please carefully read
these instructions.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN)
WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES, OR LACK OF
EXPERIANCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION
OR INSTRUCTION CONCERNING USE OF THE APPLIANCE BY PERSON RESPONSIBLE
FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH
THE APPLIANCE.
This water heater has been manufactured in compliance with the relevant standards
and tested by the relevant authorities as indicated by the Safety Certificate and the
Electromagnetic Compatibility Certificate. The technical characteristics of the product are
listed on the label affixed between the inlet and outlet pipes. The installation must be carried
out by qualified staff. All repairs and maintenance work within the water heater, e.g. lime
removal or inspection/replacement of the protective anticorrosion anode, must be carried out
by the authorised maintenance service provider.

BUILDING-IN

The water heater shall be built-in as close as possible to the outlets. When installing the
water heater in a room with bathtub or shower, take into account requirements defined in IEC
Standard 60364-7-701 (VDE 0100, Part 701). It has to be fitted to the wall using appropriate
rag bolts with minimum diameter of 8 mm. The wall with feeble charging ability must be on
the spot where the water heater shall be hanged suitably reinforced. The water heater may
be fixed upon the wall only vertically.
TECHNICAL PROPERTIES OF THE APPLIANCE
Type
Model
Volume
Rated pressure
Weight / Filled with water
Anti-corrosion of tank
Power of electrical heater
Number and power of heating
elements
Connection voltage
Protection class
Degree of protection
Heating time to 75 °C
1)
Quantity of mixed at 40°C
Energy consumption
2)
1) Time for heating of the whole volume of heater with electric immersion heater by entering temperature
of cold water from water supply 15°C.
2) Energy consumption to maintain stable temperature of water in the water heater 65°C at surrounding
temperature 20°C, measured according to EN 60379.
10
OGB 30 E3
OGB 30 SEDD/
UNI
[l] 30
[MPa]
[kg] 19/49
[W] 2100
[W] 3 x 700
[V~]
[h] 1
05
[l] 54
[kWh/24h] 0,69
OGB 50 E3 OGB 80 E3
OGB 50 SEDD/ OGB 80 SEDD/
UNI UNI
50 80
0,6
24/74 31/111
Emailed & Mg Anode
230
I
IP24
1 3
55 05
96 151
0,94 1,30
OGB 100 E3 OGB 120 E3
OGB 100 SEDD/ OGB 120 SEDD/
UNI
100
36/136 41/161
2000
2 x 1000
3
55
199
1,54
UNI
120
4
35
238
1,79