INSTALL & SETUP
Always test the product in location before installation. Be aware that different materials in between the Outdoor
Intercom and Indoor Monitor will affect the operating performance of the product. Follow the Wiring
and pairing guides to test the product. Install the Outdoor Intercom in a dry location if possible.
Mount the Intercom at a suitable height and position to allow the camera to see the visitor.
BATTERY INSTALLATION:
Outdoor Intercom
1. On the side of the Outdoor Intercom there is a battery compartment. Slide the cover open by pushing it up.
2. Insert the battery pack into the holder making sure it is inserted correctly with the "Li-ion rechargeable battery" text
facing the front, please see image.
3. Slide the cover down and "Click" into position.
Indoor Monitor
1. On the back of the Indoor Monitor open the battery cover (16) by sliding it down.
2. Insert the battery pack into the holder making sure it is plugged in correctly. Please see image.
3. Slide the battery cover up and "Click" in position.
WALL MOUNTING
1. Select the location for the Outdoor Intercom and using the rain cover as a template mark and drill the holes to
allow the supplied wall plugs to be fitted. (fig 1)
2. Also mark and drill the hole required for the power cables to go through the wall. (fig 2)
3. Push the power cables from the inside of the wall so they are visible on the outside. (fig 3)
4. Stick the sealing pad on the inside of the rain cover. (fig 4)
5. Secure the rain cover into position using the fixings supplied. Pay attention to the angle bracket (fig 5) on the
bottom fixing making sure the power cables are pushed through the back plate seal hole on the bottom right.
6. Secure the power cables into the Intercom as per the wiring diagrams below.
7. Insert the intercom top first into the rain cover and put the bottom into position over the angle bracket.
8. Secure the intercom into position on the rain cover using the securing screw. (fig 6)
6
2
3
1
2
3
EN
4
5
6