Operation Instructions; Operation Modes; Selecting Mode; Fan Mode - DIAL J1-72 Manual De Instrucciones

Operation instructions

Operation modes

Selecting mode

Each time the MODE button is pressed, the operation
mode is changed in sequence:
COOLING DRY
Heating mode is NOT available for cooling only air conditioner.
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
Auto Higher
In "FAN ONLY" mode, "Auto" is not available.
In "DRY" mode, Fan speed is set at "AUTO" automatically, and the
"FAN" button is disabled.
Setting temperature
Press once to raise temperature setting by
Press once to lower temperature setting by
Range of available set temperatures
*HEATING, COOLING
DRY
FAN ONLY
Note: Press and hold "MODE" and "
for 3 seconds to alternate the temperature display between the °C
and °F scale.
Note: Heating mode is NOT available for cooling only models.
Note: In "Dry" mode, the unit can decrease or increase the room
temperature 7°F.
Press button the RUN indicator of the indoor
unit will light up when the unit turns on.
SWING, SMART, TIMER ON, TIMER OFF, CLOCK, 8° HEATING, SLEEP and SUPER operation modes
will be specified in the following pages.
There may be a 3 minute delay when changing modes during operation of the unit.
At the beginning of the heating operation, there may be a 2-5 minute delay before air flow is discharged from the unit.
If the appliance stops during operation, wait 3 minutes before restarting the appliance.
FAN ONLY HEATING

FAN mode

High Low
Medium
61°F ~ 86°F(16 ℃
-7 ~ 7
unable to set
" buttons simultaneously
Turning on
1
Lower
1°F or 1℃.
1°F or 1℃.
℃
~30 )
3
8
ON ON
OFF OFF
ON/OFF
MODE FAN
3
SWING SLEEP SUPER
SMART
IFEEL DIMMER
TIMER ON TIMER OFF CLOCK
MUTE 8
SWING HEAT