Power Source - oneConcept 10031564 Manual De Instrucciones

Power supply
This CD player operates on two 1.5 V DC "AA" size (UM-3) alkaline batteries (not included)
or AC USB adaptor with an output of 4.5 V DC 500 mA (not included).
Install batteries into the player
1. Open the battery compartment cover located on bottom of cabinet.
2. Insert two 1.5 V DC "AA" size (UM-3) alkaline batteries (not included) into the battery
compartment following the polarity markings as indicated in the compartment.
3. Close the battery door.
Important: Be sure that the batteries are installed correctly. Wrong polarity may
damage the unit and void the warranty.
Battery note and care
1. Danger of explosion if the battery is replaced incorrectly. Replace only with the same
or equivalent type
2. Do not mix old and new batteries.
3. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batter-
ies.
4. If the unit is not to be used for an extended period of time, remove the batteries. Old
or leaking batteries can cause damage to the unit and may void the warranty.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer's directions).
6. Do not dispose of batteries in fire, batteries may leak or explode.
Using an USB adaptor (not included) to power the unit)
1. Before connecting the adaptor to the player, make sure that the AC voltage of the
adaptor corresponds to you local AC outlet voltage. The polarity of the adaptor must
match to the polarity markings next to the USB jack on the player.
2. Plug the 4.5 V DC 500 mA AC-DC adaptor into an AC outlet.
3. Insert the DC plug into the DC IN jack on the player.
NOTE: When the USB adaptor is connected, the batteries will be automatically
disconnected and the player will now operate on the adaptors power. Once
the adaptor is unplugged the player will automatically switch to back to
battery power.

Power Source

15