Favero CONTROL-CARDS-8 Instalación Y Funcionamiento página 3

CONTROL-CARDS -8/-16
Installation and working
INSTALLATION
Fix the CONTROL CARDS to the wall and insert the packs of cards
between the special guide rails. These last mentioned can be wide-
ned manually if the pack is too thick to permit easy entry.
The maximum dimensions of the pack that can be inserted are:
width 70mm, thickness 30mm.
Check that the input voltage indicated on the supplied feeder
corresponds to the grid voltage.
Insert the feeder into a live socket.
Connect the CONTROL-CARDS to the timer clock/tariff meter
supplied (model Micro8 or Micro32) according to the following
instructions:
For the MICRO8 :
Insert the telephone plug into the socket shown by the
CONTROL-BALL situated on the rear of the Micro8.
Turn on the Micro8 and, following the instructions in its
manual, define the packs of cards that you wish to control using
the BOX key and the numbers keys.
For the MICRO32 :
Insert the telephone plug into one of the two CONTROL-BALL
sockets situated at the rear of the Micro32 (socket marked by
1-16, if you wish to control the packs with the 1-16 keys, carry
out the same procedure for sockets 17-32).
Then, following the instructions in the Micro32 manual, carry out
the programming step shown on P.13, and define the numbers
which correspond to the packs of playing cards that you wish to
control.
If the CONTROL-LAMP accessory is used to command the automa-
tic lighting of the table lamp, see the relative instructions in the
Micro8 or Micro32 manual.
WORKING
When a pack of cards is taken out of the container the automatic
start, together with the lighting up of the light on the corresponding
numbered key, takes place.
When the pack is re-inserted into the container the light will flash on
the corresponding numbered key to indicate that the game is over.
Press the STOP key and then the flashing numbered key, the fla-
shing will stop and the amount to be paid will be visualised.
For further information on the working, read the Micro8 and the
Micro32 manual.
ENGLISH