Listening To Your Ipod; Control Volume - HDMX Audio HMDX-S50 Manual De Instrucciones E Información De Garantía

Listening to your iPod

1. Press POWER button on base unit. Button will glow blue to indicate base
unit is on. (Fig. 1).
2. Turn speakers on by rotating volume dial under each speaker clockwise.
Dial will click once as you rotate and glow blue to indicate speaker is on.
(Fig. 4)
Note: Both base unit and speakers need to be turned on to listen to
your iPod.
3. Press PLAY/PAUSE button on iPod to pause play; press again to resume
play.
4. Press – or + on base unit to adjust volume. (Fig. 1)
5. To turn unit off, press POWER button on base unit. Button will no longer
glow blue indicating it is off.
6. To turn speakers off rotate volume dial on each speaker counter clockwise
until dial clicks once and no longer glows blue.
Note: If the speakers have interference or static during play, adjust
channel by sliding channel control on back of unit. (Fig. 3). Select
from channel 1, 2, or 3 to achieve best sound signal.

Control Volume

You can adjust volume for each individual speaker or adjust volume for both
speakers from the HMDX-S50 base unit.
1. To adjust volume of each individual speaker, rotate volume dial under
speaker until you reach desired volume (Fig. 4). This can be done with the
speaker in or out of charging pads.
2. To adjust volume of system, use – or + buttons on HMDX-S50 base unit.
This can be done with speakers in or out of the charging pads. (Fig. 1)
3. For maximum volume rotate volume dial fully clockwise on each speaker,
and push + on front of unit until you have maximum volume.
Note: When iPod is in dock, volume is controlled through HMDX-
S50 unit, not by iPod click wheel.
8
Listening to a non-docking iPod or other
portable audio devices
If you are using an iPod without a docking port, other MP3 player, or other
portable audio device, you can play it through the unit via the LINE IN jack
located on the back of the unit. (Fig. 6)
1. Plug one end of the Connection Cable (included) (Fig. 1) into the
headphone or line-out jack on your audio device and the other end of the
Connection Cable into the unit's LINE IN jack located on the back of the
unit (Fig. 6).
2. Press the POWER button on the unit to turn it on (Fig. 1).
3. Turn on and play external audio device.
4. Press the '–' or '+' button on the unit to adjust volume (Fig. 1).
Note: You may need to adjust the volume on external device too.
5. To turn unit off, press the POWER button on the front of the unit (Fig. 1).
Note: You also need to turn off your external audio device as well.
LINE IN
Connection
Cable
iPod ® Shuffle
Figure 5
9