lauson AFF109 Manual De Instrucciones página 4

LAUSON
HOW TO ASSAMBLE
The only tool needed for this assembly procedure is a
screw driver
1. Assembling the cross-bar feet
First of all, loosen and remove the
Four screws from bars, next cross the bar A and bar B.
Be sure to align the four holes in the bar to the four
hole on the flange at the same time. Align the
projection on the flange with the extra hole on bar A,
then tighten the four screws and insert the base cap
down over the feet.
2. Mounting the switch box
"caution" never remove the inner pipe stopper if you remove the Inner pipe stopper service
may be necessary. Never loosen the inner pipe set screw
(1) locsen the switch box set screw by turning it to the left
(2) now place the hole in the bottom of the switch box over the inner pipe.
(3) turn the switch box set screw clockwise and tighten it firmly
MOUNTING NOSE OF THE FAN
1. Parts identification of the fan nose
1. motor
2. rear guard
3. guard lock nut
4. blade
5. blade cap
6. front guard
7. screw
2. Mounting the rear guard.
Mount the rear guard on the Motor and secure it with
the Guard
lock nut.
3. Mounting the blade
insert the blade onto the motor shaft. Tighten the blade
with
the blade cap.
4. Mounting the front guard
there are two type construtions of fan front guard, each
is assembled according to followings
5. Mounting the reticular guard
a. mounting the front guard by inserting the hook at the top side of the
front guard over the rear guard. unite them by pressing their sides in order
AFF109
4
EN