Waldbeck Cisternica Manual Del Usuario página 11

Instructions for proper use
• This device has been designed for domestic use. This clear water pump is
suitable for dirt particles up to 1 mm grain size. Under no circumstances
may the device be used in commercial or industrial areas or for purposes
other than those described.
• This device is used exclusively for water extraction, drainage and pumping
out the garden pond or cellar. The temperature of the water must not
exceed 35 °C.
• It is strictly forbidden to transport aggressive, corrosive, flammable (e.g.
motor oil) or explosive liquids as well as salt water, cleaning agents or food
with this pump. Any violation will immediately void the warranty and may
result in serious injury or damage. The pump is not suitable for commercial
use.
• The submersible pressure pump they use is intended for pumping water
at a maximum temperature of 35°C. This pump must not be used for other
liquids, in particular motor fuels, cleaning agents and other chemical
products.
• This pump is particularly suitable as a cistern pump. Installed in a shaft,
this pump provides protection against flooding. But it can also be used
wherever water has to be pumped around.
Installation instructions
• The submersible pressure pump is installed either stationary with a fixed
pipe or stationary with a flexible hose.
• During installation, it must be ensured that the pump is never mounted
freely suspended from the pressure line or power cable. The submersible
pressure pump must be suspended from the handle provided for this
purpose or rest on the floor of the shaft. To ensure that the pump
functions properly, the shaft bottom must always be free of sludge or
other impurities. If the water level is too low, the sludge in the shaft
can dry up quickly and prevent the pump from starting. It is therefore
necessary to check the submersible pressure pump regularly (carry out
start-up attempts). The float switch is set in such a way that immediate
commissioning is possible.
• The pump shaft should be at least 60x60x50 cm so that the float switch
can move freely.
EN
11