Pelonis FS40-8M El Manual Del Propietario página 3

ROUND BASE & COLUMN UNIT ASSEMBLY
1. Take the base and pole assembly out of the box, Loosen the fastening bolt from
the bottom of the pole assembly (see Fig. 1) .
2. Put the pole assembly into the base, and lock them together by tightening
the fastening bolt (see Fig. 2) .
3. Loosen the height-adjustment ring and adjust the internal pole to desired
height. Note: If you can't find the internal pole, it may have slid into the
external pole and can be pulled out (see Fig. 3) .
4. Loosen the thumb screw on the bottom of the head unit. Then place the
head unit on the pole and tighten the thumb screw in alignment with the
groove on the internal pole (see Fig. 4) .
CAUTION: Height adjustment ring must be fully fastened before the assembly
of the motor section to the internal pole.
Fig. 1
GUARD & FAN BLADE ASSEMBLY
1. Take the Spinner out from the bag, then remove the plastic nut by turning it
counterclockwise.
2. Place the rear guard to the head unit make sure the handle is upward.
3. Screw on the plastic nut (clockwise) securing the fan guard on the head unit.
(Step 1,2,3 see Fig.5)
4. Install the fan blade onto the motor shaft. Make sure the fan blade slot fits into
the retaining pin of the motor shaft.
5. Attach the spinner to the motor shaft by turning it counterclockwise to secure the
fan blade. (Step 4,5,see Fig.6)
6. Mount the front guard and join both guards together using the Clips.
(Step 6 see Fig.7)
Fig.5
OPERATING INSTRUCTIONS
1. Speed control
Speed is controlled by knob switch.
0--Off 1--Low 2--Medium 3--High
Fig. 2
Fig. 3
Fig.6
Fig. 4
Loosen
Fig.7
2
Mounting hole
Thumb screw
Annulargroove
Clip