NuTone 765H110L Manual De Instrucciones página 2

Ventilador con calefactor y luz
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

INSTALLATION
WARNING: To reduce the risk of fire, do not store or use
gasoline or other flammable vapors and liquids in the vicinity
of the heater.
CAUTION: High temperature, risk of fire, keep electrical cords,
drapery, furnishings, and other combustibles at least 3 feet
(0.9 m) from the front of the heater and away from the side
and rear.
HANGER
BARS
CHANNEL
1. Insert hanger bars.
Four (4) sliding hanger bars are provided to allow for
accurate positioning of housing anywhere between
framing. They can be used on all types of framing (I-joist,
standard joist, and truss construction) and span up to 24" .
Slide hanger bars into channels on housing. Make sure
hanger bar tabs face "up" as shown.
HOLE FOR OPTIONAL
SCREW MOUNTING (4)
NAIL (4)
2. Mount housing.
Extend hanger bars to the width of the framing. Hold fan
in place with the hanger bar tabs wrapping around the
bottom edge of the framing.
Nail fan to framing or fasten with screws (not provided)
through holes near nails.
* To ensure a noise-free mount: Secure hanger bars
together with screws or use a pliers to crimp mounting
channels tightly around hanger bars.
TAB
CHANNEL
HANGER
BARS
* SCREW (2)
BOTTOM EDGE
OF FRAMING
3. Attach
damper
/ duct
connector to
housing.
Snap damper /
duct connector
onto housing.
Make sure
connector is flush
with top of housing
and damper flap
falls closed.
4. Install
4-inch round
ductwork.
Connect 4-inch
round ductwork
to damper / duct
connector. Run
ductwork to a roof
cap or wall cap.
Tape all ductwork
connections to
make them secure
and air tight.
CONNECT WIRING
Installation work and electrical wiring must be done by a quali-
fied person(s) in accordance with all applicable codes and stan-
dards, including fire-rated construction codes and standards.
HEAT
BLACK to RED
(Heat)
WHITE to WHITE
WIRING PLATE
GROUND
FROM VENTILATOR
WHITE
to
WHITE
CAUTION
RATING
SPECIFICATIONS
Each two-position
rocker switch is rated 15
A @ 120VAC. The total
120 VAC LINE IN
load on this control must
not exceed 20 A @ 120VAC.
MODEL 765H110L
Page 2
LIGHT
&
FAN
VENTILATOR
HOUSING
RED to BLUE
(Light)
BLACK to BLACK
(Fan)
WHITE to WHITE
BLACK
LIGHT
FAN
HEAT
Tabla de contenido
loading

Tabla de contenido