PROZIS PULSE hex Manual Del Usuario página 9

Buttons
• Press the ON/OFF button to turn on the device. It will buzz and the
LED light will flash once.
• Press the ON/OFF button again to turn the device off. It will buzz and
the LED light will flash three times.
• Press the "+" or "-" button to respectively increase or reduce output
intensity. There is a total of 15 intensity levels. After turning it on, the
device will operate on intensity level 1. Every time the intensity is
adjusted, the device will buzz, and the LED light will flash once. When
the highest or lowest intensity is reached, it will buzz twice.
Use
Before using the device, make sure the targeted body parts are clean
and dry. At this point, peel the transparent film off the Gel Pads. Place
the device onto the targeted area (back, shoulders, arms, legs, etc.)
and press down firmly for maximum skin contact. Always start on low
intensity – you can gradually increase it according to your preference.
TIPS
• Make sure you replace the battery in time. If you notice weakened
buzzing, decreased intensity or a dimmer LED light color, that means
the battery is low.
• Turn the power off after use and before removing the device from
your body.
• Once removed from the body after use, place the device on the
Pad Holder and store it in the Carrying Bag to prevent the gel from
getting dirty and drying out.
• The electrode Gel Pads are disposable. When used for 20 minutes
each time, they can be used about 30 times, depending on the type
and intensity of use. The Gel Pads should be replaced when they
have lost their adhesiveness. Keeping the pads clean will extend their
lifespan. Avoiding touching the adhesive area with your fingertips will
make them last longer.
manual-pulse-hex.indd 9
Increase the intensity
LED light
Reduce the intensity
On/Off
EN
9
2019-04-19 09:37