AERMEC STA Manual Del Usuario página 9

Fig.1
Fig.2
Fig.4
5
4
6
Fig.5
Esploso AT******C*
5
4
6
Display
1 3
2
12
11
10
1.
2.
3.
connections
4.
Fig.3
230 Vac
5.
6.
Disassembly
Insert a screwdriver into the upper slot (Fig. 1) and press to remove the display
Keypad
The meaning of the buttons and displays can vary depending on the control to
which the STA/STH is connected. A description of the standard settings follows.
Addressing
1.
2.
3.
4.
5.
Keypad
Access to special menus: MODE + CLOCK for 3s to access the alarms menu, active only if the
icon is on.
The meaning of the buttons and displays can vary depending on the control to
which the STA/STH is connected. A description of the standard settings follows.
4
5
6
7
8
1
9
2
3
4
5
6
7
8
9
10 Actuator on
11 Secondary fi eld
12 Time slots on
separate the front of the terminal from the back using a screwdriver
( fi g.1);
disconnect the 5-pin connector from the front
(fi g.2);
make the electrical connections: see (fi g.3);
fi x the back to the fl ush box with the two supplied screws:
• for round fl ush models, insert the screws as shown in (fi g.4);
• for rectangular fl ush models, insert the screws as shown in (fi g. 5);
insert the 5-pin connector again;
fi nally, reinstall the terminal, starting from the lower teeth with a hinge move-
ment. Make sure the electrical wires enter to have the correct snap connection.
Press FAN and POWER for 5 sec.
Enter the password 22, and press PUSCH
Turning the adjustment knob
Having found "addr", press
- PUSH
1 and 5, press to confi rm
PUSH
- +
Turning the adjustment knob
-
confi rm and exit.
Key Description Pre-heating
mode MODE NOT USED
FAN NOT USED
NOT USED
POWER ZONE On/Off
Knob allows you to change the setpoint. Turn the knob to set the
PUSH
-
+
Adjust. value and press to confi rm
Operating mode
Main fi eld
Fan speed in manual/automatic mode
Fan speed indication
Temperature reading unit
Set point
Relative humidity
Current time slot
Day of the week
, search the wording "addr".
PUSH
- +
and enter the address comprised between
+
, search the wording "esc", press
PUSH
+
STA_STH_ 4804200 _02
, to
PUSH
- +
9