Idiomas disponibles
Idiomas disponibles
1
1
4
3
2
Scope of supply:
2x handguards, closed
2x assembly kits
These hand guards do not provide protection against injury.
Preparations
- Cut off the ends of the left and right rubber grips (approx. 3 mm from the
edge) with a sharp knife.
- Push back the rubber grip on the throttle twist grip somewhat.
- Release the screws (1) and slide the throttle twist grip outward by approx.
20 mm.
- Saw off the end of the throttle twist grip (approx. 3 mm from the edge)
(Figure A).
A
Do not damage the handlebar when sawing.
- Deburr the edges of the throttle twist grip if necessary.
- Properly mount the throttle twist grip (for Nm, see the Owner's Manual).
Assembly
4
NOTE:
The assembly steps apply to both the left and right sides. Do not overtighten
screws.
- Attach the handguard to the handlebar end using the screw (2) and bus-
hings (3).
NOTE:
Turn the screw (5) until it catches the thread.
5
- Attach the handguard to the handlebar using the handlebar clamp (4) and
the screws (5) and tighten the screws.
- Tighten the screw (2).
Check the screw connections again and ensure that all control elements, espe-
cially the coupling, brake and throttle, are functioning properly.
Smooth operation and correct functioning of the controls need to be che-
cked regularly.
