Seitron TCD01B Manual Del Usuario página 17

OVERVIEW
This device is an electronic daily programmable thermostat with
an ample backlit display for showing the room temperature reading
or current time, as desired. The room temperature can be set in the
Heating or Cooling mode on two different levels: Comfort and Economy.
In addition, the device offers the option of setting the Antifreeze
temperature and adjusting the Offset value on the internal sensor.
STARTING
When operating the device for the first time:
Fit the batteries into the compartment provided, observing proper
polarity (Fig. 4). Reset the device by inserting a pointed implement
through the hole provided (L on Fig. 4); DO NOT USE NEEDLES.
There are three control buttons beneath the lower cover 3:
'OK': Programming/Time/Confirm (I on Fig. 4);
' ': Forward (G on Fig. 4);
' ': Back (H on Fig. 4);
Setting the current time
To set the timer thermostat clock carry out the following steps:
1. Open the cover of the battery compartment.
2. Press the ' OK ' button for at least 2 seconds.
3. Set the hour using buttons ' ' and ' '.
4. Confirm with ' OK '.
5. Set the minutes using buttons ' ' and ' '
6. Confirm with ' OK '.
Setting the Heating / Cooling modes
Pressing button ' ' for at least 4 seconds will activate the 'Heating'
function and the ' ' symbol will appear flashing on the display.
Pressing button ' ' for at least 4 seconds will instead activate the
'Cooling' function and the '
display.
Setting the Comfort and Economy modes
The timer thermostat has 24 switches (A on Fig. 4), situated
alongside the display, for programming operation in the 'Comfort' or
'Economy' modes at different times of the day.
When you want the timer thermostat to operate in the comfort mode,
for example during the daytime, move all the switches corresponding
to the desired time interval over to the right.
If you want the timer thermostat to operate in the economy mode,
for example during the nighttime, just move all of the switches
corresponding to the desired time interval over to the left.
In this case it is sufficient to remember the following rule:
Switches positioned to the right: The comfort setting is enabled in
Switches positioned to the left: The economy/night setting is
Each switch corresponds to the interval falling between the times
printed above and below the switch itself.
For example, note that the time interval from 00 to 05 is controlled by
a single switch, whereas from 05 to 09 in the morning settings can
be made at half-hour intervals. For the rest of the day, the selectable
time intervals are one hour each (A on Fig. 4).
The Comfort temperature is set by means of knob ' ' (Sun), whereas
the Economy temperature is set by means of knob ' ' (Moon).
17
' symbol will appear flashing on the
the automatic operating mode.
enabled automatic operating mode.