ASROCK K7S41 Manual Del Usuario página 12

Clear CMOS
(CLRCMOS1, solder points)
(see p.2/p.3 No. 11)
Note: CLRCMOS1 and CLRCMOS2 allow you to clear the data in CMOS. The data in CMOS
includes system setup information such as system password, date, time, and system
setup parameters. There are 2 ways for you to clear and reset the system parameters to
the default setup. Please turn off the computer and unplug the power cord, then you may
either short the solder points on CLRCMOS1 by using metal material, e.g., a paper clip for
3 seconds; or you may use a jumper cap to short the pin on CLRCMOS2 for 3 seconds.
Please remember to remove the paper clip or the jumper cap after clearing the CMOS. If
you need to clear the CMOS when you just finish updating the BIOS, you must boot up the
system first, and then shut it down before you do the clear-CMOS action.
FID Jumpers
(FID0, FID1, FID2, FID3, FID4)
(see p.2/p.3 No. 30)
Note: The set of FID jumpers are designed to adjust the multiplier of CPU. For detailed
information, please refer to page 15 of user Manual in the Support CD.
2.5 Connectors 2.5 Connectors 2.5 Connectors 2.5 Connectors 2.5 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over these
connectors. Placing jumper caps over the connectors will cause perma-
nent damage of the motherboard!
Connector
FDD Connector
(33-pin FLOPPY1)
(see p.2/p.3 No. 17)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
1 2 1 2 1 2
1 2 1 2
ASRock K7S41 / K7S41GX Motherboard
(CLRCMOS2, 2-pin jumper)
(see p.2/p.3 No. 12)
solder points
Figure
2-pin jumper
Description
the red-striped side to Pin1