Troubleshooting - Oreck XL AIRP Serie Guía De Usuario

Troubleshooting

Service problems that appear to be major can often be solved easily. You can be your own troubleshooter
by reviewing this guide. All other servicing should be done by an Oreck authorized service center.
Problem
Unit does not turn on.
"Check Collector Cell"
has turned red.
"Check Collector Cell"
light is flashing red.
Unit does not
remove pollutants.
Unit sparks, crackles
and pops.
"Check Odor Absorber"
light has turned red.
Does not remove odor.
Unit still does not
operate properly.
E N G L
Check
• Power Cord
• Power Button
• Front Grill
• Top Cover
™
• Truman Cell
• Truman Cell ™
• Truman Cell ™
• Truman Cell ™
• Odor Absorber
• Odor Absorber
• Check all the
above points.
11
I S H
What to do
• Plug in the power cord.
• Set power button for desired blower speed.
• Reinsert front grill, sliding right until it locks
into place.
• Top cover should be replaced and slid back to lock.
• Wash Truman Cell
thoroughly clean and dry before reinstalling.
• Hold down theAir Revitalizer button until the light
blinks three times to reset the timer after cleaning.
• Truman Cell ™ may need cleaning.
Clean Truman Cell
• Truman Cell ™ may not be completely dry.
Allow it to air dry longer.
• Truman Cell ™ may be damaged.
Contact Oreck for service.
• Wash Truman Cell
thoroughly clean and dry before reinstalling.
• Sparking or popping noise (arcing) can occur
when dust particles build up in the Truman
Cell ™ . Gently wipe the cell wires with a dry
cotton swab, or clean the entire cell with
Assail-a-Cell or soapy water.
• If excessive arcing continues after proper
cleaning, the cell may be damaged or wet.
If damaged contact Oreck for service.
• Hold down the Night Light button until the
light blinks three times to reset the Check
Odor Absorber timer after replacing.
• Replace odor absorber if desired.
• If the odor absorber is not replaced, remove
old odor absorber to turn off "Check Odor
Absorber" light.
• Vacuum odor absorber with a soft brush
attachment if dirty. Do not use any liquids to
clean the odor absorber.
• Replace odor absorber if desired.
• Contact Oreck for service.
™
. Make sure it is
™ .
™ . Make sure it is