Whittier Wood Products 747W Instrucciones Para Armar página 11

ZA
x 12
ZB
x 12
FIG. 16
16. Install Adjustable Shelves (N & O) using the Shelf Brackets (ZA) and Screws (ZB) at desired
locations. Make sure the front edges of each shelf is flush with the front edge of either Vertical
Divider (A).
ZD
x 8
Hinge
Arm
ZD
ZD
FIG. 17
17. With the Doors (P) laying face down on a clean protected surface, place a Hinge (ZC) in each
large hole in the back of each door. For each Hinge (ZC), line up the screw holes in the hinge
with the pre-drilled holes in the door and insert Screws (ZD). See FIGURE 17.
18. Holes are pre-drilled in each Side (C & D) to mark the locations of the screws for each Hinge
Plate (ZE) and Hinge Spacer (ZF). Since it may be difficult to see these holes through the hinge
spacers we recommend that you start a Screw (ZG) into each hole to make it easier to align.
Remove the screw and insert through the Hinge Plate (ZE) and Hinge Spacer (ZF). With the
long arm facing out (arrow on plate points out), fasten each set in place with Screw (ZG). See
FIGURE 18.
O
A
ZC
DOOR
N
A
Flush
ZG
x 8
ZG
ZG
FIG. 18
N/O
ZB
FIG. 16A
Side
ZF
ZE
747W — Page 11
ZA