S&P DHUM-12 EN Manual Del Usuario página 23

Note: The device incorporates a delay system which causes it to wait for approximately 3
minutes before starting to operate, in order to protect the compressor. At the end of the delay
period, it starts working automatically and the indicator light
• Using the button
line, a comfortable relative humidity level in a room at a temperature of 22ºC would be in
the range 55-60 %HR.
Once the required relative humidity has been selected, the relative humidity display indicator
(Fig. 2(h)) ceases to blink and indicates the current relative humidity in the room. If it is hig-
her than the required humidity, the device commences its dehumidifi cation function. If it is
lower, the device remains in a waiting state (functioning only as a fan) with the indicator light
blinking.
CO 30 35
CO: Continuous operation mode.
AU: Automatic operation mode.
Note:
a) If the % HR in the room is below 30%, the display shows "LO" and the device will remain
in standby mode, only the fan is working.
b) If the % HR in the room is over 90%, the display shows "HI" and the device will start the
deshumidifi cation process.
Continuous operation mode (CO)
If the user selects this option, the humidifi er remains in operation permanently, regardless
of the level of humidity in the room. Use of this mode is recommended when the level of hu-
midity in the room is high.
Automatic operation mode (AU)
If the user selects this option, the dehumidifi er self-regulates automatically depending on the
temperature in the room and the following operating settings.
Room temperature (TºC)
TºC < 5ºC
5ºC < TºC < 20ºC
20ºC < TºC < 27ºC
TºC > 27ºC
• By using the speed selector
Fast Speed: Hi
Slow Speed: Low
, select the required relative humidity for the room. By way of a guide-
...
40 80 85
, you can set the speed of the fan:
ceases to blink.
90 AU
Operating settings
Compressor Stop
60%
55%
50%
23