Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Case #2:
Only one of the 2 motor buttons is locked and does not "click" when pressed.
Make sure you release the mechanism. To do this, remove the track
the motor and remove the
1.
Test the
red and blue
should emit a "click" sound. Press and hold the
button
that "clicks", until you complete step 3.
2.
On the wall control, press either
button
until the motor stops on its own. If the
button you pressed does not start the motor, or if
after several minutes the motor does not stop, try
this step again using the opposite
button
to the one previously selected.
3.
Press and release the
release the button that was pressed on the motor.
4.
red
blue buttons
Test the
and
time, both buttons should be able to emit a
"click" sound when pressed. Both buttons are
now unlocked, allowing for new limits to be set.
The motor is now set to its factory default settings. Place the
procedure to adjust the limits
IMPORTANT:
•
The values, recommendations and instructions in this manual may vary at any time without previous notice.
They are not contractual and can not be used as claim for defective merchandise, order cancellations or returns.
•
The process of transportation of the motor may cause a slight spill of the grease used for the internal lubrication
of the motor. This does not affect its operation. Clean the lubricant residues with a dry cloth to avoid stains on the
6
slats or panels during the shade fabrication process.
For additional information contact your Vertilux representative or Vertilux Authorized Dealer.
GEAR
to release the mechanism
buttons. One of them
direction
direction
stop button
and then
again. At this
(p.
3).
COVER
located on the side of
(p. 2, fig.
2).
RED OR BLUE
BUTTON IS
UNLOCKED
DIRECTION
BUTTON
STOP
BUTTON
RED AND BLUE
BUTTONS ARE
UNLOCKED
GEAR
back. You can now follow the
RELEASE
RED OR BLUE
BUTTON
Tabla de contenido
