Kohler K-16112 Guia De Instalacion página 3

Shank
Body
Dished
Washer
Ferrule
Coupling
Nut
1. Install the Faucet Body
Apply a bead of plumbers putty or other sealant to the underside
of the faucet shank body according to manufacturer's instructions.
Insert and align the faucet through the top of the sink.
From under the sink, install a dished or crimped washer
(depending on thickness of sink). Secure with the spout nut.
If the sink is not installed, install it at this time.
Slide the coupling nuts and ferrules onto the supply tubes.
Carefully insert the supply tubes into the faucet inlets and
shut-off valve outlets (if used).
Secure with coupling nuts.
2. Installation Checkout
Ensure that all connections are tight.
Remove the aerator (if spout is installed).
Open the drain.
Turn on the main water supply and check for leaks. Repair as
needed.
Open both hot and cold valves and run water through the spout
(if installed) for approximately one minute to remove debris.
Check for leaks. Turn the valves off.
Remove any debris from the aerator and reinstall (if spout is
installed).
Kohler Co.
Apply plumbers
putty.
Faucet Inlet
Crimped Washer
Supply Tube
Spout
Coupling Nut
Nut
Ferrule
Shut-off
Valve
3 113286-2-BC