Craftsman 917.249910 Manual Del Usuario página 7

5
INSTALL DEFLECTOR GUARD
(See Fig. 5)
1. Using the deflector guard as a template, hold deflector
guard on the top of the deflector aligning edge with the
holes with bottom of writing and angled end with the
rear of the deflector as pictured.
2. Mark locations of (4) holes and drill using supplied #7
drill bit.
3. Insert screws from bottom through deflector and guard,
place washer and then acorn nut on top of guard.
Tighten with a screw driver and 3/8 wrench.
CAUTION: When using mower with out
bagging attachment and with the blade
supplied with this kit, the deflector
guard must be installed.
DEFLECTOR
SHIELD
ACORN NUT
WASHER
SCREW
DEFLECTOR
GUARD
Fig. 5
6
LOWER CHUTE (See Fig. 6)
1. Raise and hold deflector and metal shield in upright
position.
2. Place slot in lower chute over mounting tab on mower
and position lower chute over mower opening as
shown.
3. Hook rear latch into flange hole on back of mower.
4. Hook front latch into tab hole on front of mower.
CAUTION: Do not remove deflector
shield from mower. Raise and hold
shield when attaching lower chute
and allow it to rest on chute while in
operation.
TAB
7
DEFLECTOR
SHIELD
FRONT
LATCH
REAR LATCH
Fig. 6