Tabla de contenido
4. Funcionamiento
4.1 Operation method
① Turn on the power switch on the rear side of the main body of the product.
② Make sure if the LED light on the front side of the Controller is turned on.
③ Select the Handpiece user wants to use, the direction of turning of the Handpiece and select from between
hand drive mode or foot drive mode.
④ If hand drive mode is selected, regulate the speed of Handpiece by adjusting the Speed control Knob.
⑤ If foot drive mode is selected, please adjust the Speed control knob to a speed you want and then drive the motor
by pushing the pedal of the Foot switch.
⑥ It can control the quantity of water injection through Water Injection Regulation Knob
- Turning counterclockwise increases the amount of water, and turning clockwise decreases the amount of water.
⑦ Before use, check if the handpiece collec chuck is locked by turning the handle of the handpiece or pulling the bur.
4.2 Operation of functions
1) High speed handpiece LED selection
[
] Auto cruise button
It is operated only when high speed handpiece is connected.
▶ Press this switch and drive the handpiece to turn on the LED. Pressing the switch once again turns off the LED
on the handpiece.
2) Auto cruise mode selection
[
] Auto cruise button
It is operated only when foot Switch is connected.
▶ If you press this switch for 2 seconds, the green LED on the button flashes. At this time, set the desired speed
and press the scaffold for 5 seconds, the beep sounds, the red LED on the button lights up, and the handpiece
operates at a constant speed even if you release the foot switch. Pressing and releasing the foot switch again
stops the handpiece, the green LED blinks, and speed is adjustable. At this time, if the Auto cruise button is
pressed for 2 seconds, the automatic operation mode is canceled.
3) Handpiece selection
[
] Handpiece selection button
▶ You can select between High Speed Handpiece and Low Speed Handpiece you want to use by pushing this switch.
When low speed handpiece is selected, the LED above the button lights up in green. When high speed handpiece
is selected, the LED above the button lights up in red.
10/14
Tabla de contenido
