Idiomas disponibles
Idiomas disponibles
RX MULTI 240v: CONTROL BOARD FOR ROLLER SHUTTER
7. How to entry a remote and erase memory
Entry one button for Open or Close:
1. Press button S1 until the LED L1 turns on. Press any button on the remote
twice, LED1 L1 will flash quickly about 4 seconds. The remote is working now.
2. Repeat step for up to 250 remotes.
Erase all data in memory:
Pressing and holding the button S1, the LED L1 starts flash. Keep pressing this
button until the LED turns off. All data in the memory card will be erased
permanently.
Attention: be careful of erasing all data in the memory card. The data will be
erased and can not be recovered.
8. How to work
After the remote is programmed into the roller box, the box can work by remote
and/or button on board or external button.
Work by remote
The different buttons on the remote work as different commands, for example,
one button works for Open, another one for Close and the other for Stop. The
details are showed in the table 1.
1. Press OPEN button on the learnt remote. The motor will work opening until it
reaches full open limit.
2. Press CLOSE button on the learnt remote. The motor will work closing until it
reaches full close limit.
3. Press STOP button on the learnt remote. The motor will stop.
Work by external button OP/STOP/CL
External button OP/STOP/CL works similar to the remote.
1. Press external button SWITCH1, the motor will work opening until it reaches
full open limit.
2. If SWITCH 1 is pressed WHILE OPENING MANEUVER, the motor will stop.
3. Press external button SWITCH2, the motor will work closing until it reaches full
close limit.
4. If SWITCH 1 is pressed WHILE CLOSING MANEUVER, the motor will stop.
Work by button S2 (Test)
Button S2 (test) works OPEN/STOP/CLOSE mode.
Press S2 once, the door will open, press S2 again, the motor will stop.
Press again, the motor will close.
