Chicco Goody Plus Manual De Instrucciones página 7

INSTRUCTIONS
FOR USE
GOODY PLUS STROLLER
ADAPTORS
IMPORTANT - PLEASE READ THESE
INSTRUCTIONS CAREFULLY AND KEEP
THEM FOR FUTURE REFERENCE
WARNING: BEFORE USE, REMOVE AND
DISPOSE OF ALL PLASTIC BAGS AND
PACKAGING MATERIALS
THEM OUT OF REACH OF CHILDREN.
WARNINGS
• WARNING: The adaptors can only be used
with the Goody Plus stroller.
• WARNING: Only CHICCO KAILY and KIROS
I-SIZE FAST IN Child Car Seats can be installed
on these adaptors.
• WARNING: Before use, check correct fixing
of the adaptors to the frame of the stroller.
• WARNING: Before use, make sure that the
child car seat is correctly fitted on the adap-
tors by pulling up on the car seat.
• Keep adaptors out of reach of children when
they are not in use.
INSTALLATION AND USE OF ADAPTORS
WITH THE CHICCO KAILY CHILD CAR SEAT
Before installing the adaptors on the stroller,
remove the bumper bar.
1. Place the adaptors on the frame of the stroll-
er and run the plastic component, found on
the edge of the adaptor, over the bumper
bar area (Fig. 1-1A). Fasten the adaptors by
closing the plastic levers on each side (Fig.
1B). Once the two adaptors have been
properly mounted on either side, the stroller
is ready to be attached to the child car seat
(Fig. 1C).
WARNING: Before installing the Child Car
Seat, check that the adaptors are mounted
correctly.
2. To install the CHICCO KAILY Child Car Seat,
recline the backrest of the stroller and then
insert the lateral hooks of the child car seat
into the adaptors that were installed previ-
ously (Fig. 2-2A). The car seat should be fixed
only and exclusively facing parent.
3. To remove the Car Seat press the button on
the back and pull upwards (Fig. 3).
FAST-IN
INSTALLATION AND USE OF ADAPTORS
WITH THE CHICCO KIROS I-SIZE FAST IN
CHILD CAR SEAT
Before installing the adaptors on the stroller,
remove the bumper bar.
Connect the adaptors to the frame of the
stroller as described in Point 1.
AND KEEP
WARNING: Before installing the Child Car
Seat, check that the adaptors are mounted
correctly.
4. To install the CHICCO KIROS I-SIZE FAST IN
Child Car Seat, recline the backrest of the
stroller and then insert the lateral hooks of
the child car seat into the adaptors that were
installed previously (Fig. 4-4A). The car seat
should be fixed only and exclusively facing
parent.
5. To remove the CHICCO KIROS I-SIZE Child
Car Seat, press the buttons under the handle
on both sides and pull upwards (Fig. 5-5A).
DISASSEMBLING THE ADAPTORS
WARNING: It is not possible to close the
stroller when the adaptors are mounted on
the frame.
6. To release the adaptors turn the plastic le-
vers outwards (Fig. 6) and pull up. Once the
adaptors have been unhooked, the bumper
bar previously removed must be fixed back
on again.
ADVICE
MAINTENANCE
The cleaning and maintenance of the product
must only be carried out by an adult.
CLEANING
After possible contact with water, dry the met-
al parts in order to avoid the formation of rust.
Do not use solvents or abrasive products to
clean the plastic components. After use, keep
the adaptor in a dry place.
7
FOR CLEANING AND