TIE DOWN 13864 Instrucciones De Instalación página 6

WARNING
Personal Fall Arrest: Structure must withstand loads of at least
5,000 lbs. 2-Way Standing Seam Roof Clamp may be used to support
a MAXIMUM 1 PFAS for use in Fall Arrest applications. Maximum free
fall is 6', or up to 12' if used in combination with equipment explicitly
certified for such use.
Prior to Installation, Plan Your System:
1. All PFAS equipment must be selected and deemed compatible with 2-Way Standing Seam
Roof Anchor Clamp by a Competent Person.
2. Any swing or fall hazards must be eliminated or minimized.
3. Installation location and work surface should be free of all damage, including, but not
limited to, corrosion, rot, rust, debris, and sharp or abrasive edges and surfaces.
4. Never for use in combination with horizontal lifelines (HLLs), unless HLL is installed in a
manner such that 2-Way Standing Seam Roof Anchor Clamp is not subjected to a side
load. All loading of 2-Way Standing Seam Roof Anchor Clamp must be done in-line with
standing seam; refer to anchorage positioning chart on pg. 5.
MINIMUM required standing seam roof thickness: 24 gauge.
Installation:
1. 2-Way Standing Seam Roof Anchor Clamp is designed for use on a standing seam roof ONLY.
2. 2-Way Standing Seam Roof Anchor Clamp MUST be attached to a fully seamed panel and
MUST be attached over a clip that is bolted/screwed down.
3. 2-Way Standing Seam Roof Clamp must be positioned a minimum 4' from leading edge(s)
of fall hazard(s).
4. Hook 2-Way Standing Seam Roof Anchor Clamp flange under selected roof seam. This
must be done before bolts are tightened.
5. Tighten Both outside bolts until snug, then tighten both inside bolts until snug.
6. Tighten outside bolts to 50 ft./lbs.,
then tighten inside bolts to 50 ft./lbs.
Ensure 2-Way Standing Seam Roof Anchor
Clamp is fully secured to roof seam and
no possibility exists for detachment.
7. Attach complete and compatible
PFAS to 2-Way Standing Seam Roof
Clamp O-ring.
Page 6 of 8
E1602; Rev. 8/5/19
WARNING
800-241-1806 • 404-344-0000 • www.tiedown.com
WARNING
Upper Most "Outside" Bolts
TIE DOWN Roofing Products Division
WARNING
Lower Most "Inside" Bolts