Idiomas disponibles
Idiomas disponibles
FIREWOOD CADDY
ASSEMBLY INSTRUCTIONS
For easiest assembly, follow the
assembly steps in this order.
An adjustable wrench or socket wrench
with 10MM socket is needed for assembly.
Assembly time: 10 minutes
Assemble axle rail [ CC1 ] to bottom rail [ BB1 ]
STEP
1
using (2) 35MM bolts [ M ], (2) washers [ N ] and (2)
hexnuts [ P ] as shown in DIAGRAM 1.
Repeat step for axle rail [ CC2 ] and bottom rail
[ BB2 ].
Insert axle [ E ] through holes in bottom rails. Slide
STEP
2
axle until it comes to the stops. See DIAGRAM 2
and 2B. Slide on the (2) spacers [ I ] as shown.
Slide tire and wheel [ F ] onto the axle [ E ] and
STEP
spacers [ I ]. Lock tire and wheel to axle using (1)
3
cotter pin [ J ] per side. Bend cotter pin ends to
lock. See DIAGRAM 2 and 2B.
Insert front rail [ DD ] into the bottom rails and
STEP
4
attach using (2) 35MM bolts [ M ], (2) washers [ N ]
and (2) hexnuts [ P ]. See DIAGRAM 3.
Insert handle rail [ AA ] into the axle rails and
STEP
attach using (2) 35MM bolts [ M ], (2) washers [ N ]
5
and (2) hexnuts [ P ]. See DIAGRAM 3.
Make sure all bolts are tightened securely.
STEP
6
Note the tires are only partially inflated for
STEP
shipping purposes. Carefully inflate tires to 30 psi
7
before use.
Use cover to keep firewood out of the weather.
STEP
8
DO NOT RETURN PRODUCT TO THE
STORE. IF YOU HAVE QUESTIONS OR
HAVE TROUBLE WITH ASSEMBLY,
PLEASE CALL 1-800-321-3473 FOR
ASSISTANCE.
30 PSI
!
MAXIMUM TIRE PRESSURE
WARNING!
!
DO NOT OVER INFLATE THE TIRES!
SLOWLY AND CAREFULLY INFLATE THE
TIRES TO 30 PSI. MAXIMUM TIRE
PRESSURE IS 30 PSI, DO NOT EXCEED!
P
CC2
BB2
BB1
F
DIAGRAM
2
J
DIAGRAM
2B
DD
P
N
M
DIAGRAM
3
CC1
N
NOTE: HOLD LOCKING
BOLT IN THE SQUARE
HOLE WHILE TIGHTENING
THE LOCKING HEXNUT.
M
I
E
AA
PAGE 2
DIAGRAM
1
DIAGRAM
2A
I
F
M
N
P
