Personal Safety - Monti POWER MBX AXIAL Manual De Instrucciones

EN Operating instructions
The warranty shall no apply in cases where:
- damage is caused by improper operation,
- repairs or interventions are carried out by unauthorized persons,
- accessories and spare parts are used which are not approved by the manufacturer for
use with the MBX
Breakdowns must be reported immediately upon upon dectection and all defects repaired
immediately to minimize the extent of damage and not impair the safety of the tool. Non-
compliance will void the warranty.
4. Working area
1. Keep the working area clean. Cluttered working areas and work benches pose a risk of
injury.
2. Never allow children, unauthorized persons or persons without safety goggles and other
protective equipment to enter the work area.
3. Always operate the tool in a well-ventilated work area.
4.1

Personal safety

1. Wear suitable protective clothing. Never wear loose clothing or jewelry that can be
caught by moving parts. Protect long hair with headband or hair net.
2. Always wear safety goggles, a dust mask, hearing protection, gloves and and non-slip
footwear.
3. Ensure that the tool is held safely during operation. Always ensure a firm and
secure footing.
4.2 Tool use and due diligence
1. Remove the Allen key after installing accessories such as the adaptor system and
®
MBX Belt. Always ensure that the Allen key is removed before switching on the tool.
2. Prevent the tool from being switched on unintentionally. Never carry the tool while it
is plugged in and your hand is on the start lever. Ensure that the start lever is not
actuated when the tool is connected to the compressed air line.
3. Exercise caution. Handle tool with care. Use your common sense.
4. Never operate this or any other tool when you are fatigued.
5. Do not stand next to the user during operation. Establsih a safe distance so that
persons cannot be injured by objects ejected or falling from the workspace.
6. Maintain the tool carefully. Follow the instructions for lubricating and replacing
accessories. (See Chapter 5, Compressed air supply).
7. When not in use and prior to maintenance, switch off the tool and disconnect it from
the compressed air supply.
4
®
Axial.
®
MBX AXIAL